Gearbox Mainshaft Front Bearing, Circlip Style

Excellent original equipment quality mainshaft bearing to suit mechanical clutch gearboxes, as well as early hydraulic clutch gearboxes.

This is the early style bearing for gearboxes where the input shaft bearing is retained by a circlip, rather than the large retaining nut used on later hydraulic clutch gearboxes.

Excellent OE quality, as used on all applicable standard gearbox rebuilds here at VeloceSport. As gearbox specifications can vary, we recommend checking the bearing dimensions and retaining method before ordering.

Dimensions:
Inner Diameter: 30mm
Outside Diameter: 62mm
Width: 23.9mm

Key Features:

• Gearbox Compatibility: Suitable for mechanical clutch gearboxes, including 101 series, and early hydraulic clutch gearboxes.
• Early Style Fitment: For gearboxes where the input shaft bearing is retained by a circlip rather than a large retaining nut.
• OE Quality: Excellent original equipment quality for reliable operation and long service life.
• Correct Dimensions: 30mm inner diameter, 62mm outside diameter and 23.9mm width.
• Workshop Approved: Used on all applicable standard gearbox rebuilds here at VeloceSport.
• Important Fitment Check: We recommend checking the bearing dimensions and confirming that your gearbox uses the circlip retaining system before ordering.